One ET4BF060KA - Frigidaire 5 Ton 16 SEER Extra High Efficiency Heat Pump, R410A
Frigidaire ET4BF-KA/B Series, R-410A Extra High Efficiency Heat Pump, 16 SEER. ET4BF-KA/B Series now offers the choice of the heat pump that uses a more efficient and environmentally friendly refrigerant designated R-410A. The ET4BF-KA/B Series of heat pumps offers exceptional performance as well as environmental protection. These models, when matched with our variable speed air handlers or variable speed equipped gas furnaces, offer a line of high quality heat pump systems rated up to 16 SEER and 9.0 HSPF.
- R-410A Refrigerant - Earth friendly non-ozone depleting refrigerant.
- Copeland Scroll UltraTech™ Compressor - The Ultra Tech Compressor operates with 2 stages of heating and cooling capacities to provide superior comfort and efficiency. Copeland's proven and simple design equates to years of comfort and reliability for the homeowner with virtually silent operation.
- Durable, Attractive Cabinet - Designed using galvanized steel with a polyester urethane finish. The 950 hour salt spray finish is 1.5 mil thick and resists corrosion 50% better than comparable units.
- Composite Base Pan - Absorbs sound and is corrosion resistant. Composite is also stronger and lighter than steel.
- Copper Tube / Aluminum Fin Coils - Both indoor and outdoor coils are designed to optimize heat transfer, minimize size and cost, and increase durability and reliability.
- Demand Defrost - Provides additional energy savings in heating by defrosting only when necessary.
- Louvered Condenser Guard - Durable metal guard protects the coil from yard hazards and extreme weather.
- Removable Top Grille Assembly - Allows ease of service from the top without disconnecting fan motor leads.
- Low Pressure Switch - Loss of charge protection ensures long compressor life. Auto-reset feature prevents nuisance service visits.
- High Pressure Switch - Protects against abnormally high system pressures. Auto-reset feature prevents nuisance service visits.
- Liquid Line Filter Drier - Included with unit, field installed.
- One Piece Top/Orifice - Designed for maximum airflow and quiet operation.
- Common Suction Service Port - This port allows the contractor to read the suction pressure in all modes of operation without removing any panels, saving time and increasing serviceability.
- Three Minute Restart Time Delay - When the unit shuts down, a three minute delay keeps the unit from restarting, eliminating the highest cause for compressor failure.
- Suction Accumulator - Protection from liquid flood back and future compressor failures.
- Hot Gas Muffler - Reduces compressor noise and vibration.
- Easy Compressor and Control Access - Designed to make servicing easier for the contractor, access panels are provided to all controls and the compressor from the side of the unit.
One B6VMAX60KC - Frigidaire 5 Ton 14-16 SEER Variable-Speed Air Handler, R410A, 22 1/2" W Cabinet
Frigidaire B6VMAX Series, Air Handler with TXV, 14-16 SEER, R-410A Refrigerant, Features:
- Energy Efficient Variable Speed ECM Motor: Advanced technology provides 16 field-selectable cooling airflows and automatically sets heating airflows based on the amount of installed heat.
- Quiet Blower Operation: Extra quiet and smooth blower on and off cycles.
- Constant airflow: Motor automatically adjusts to different static loads.
- Reduced air stratification: This results in improved air quality by optimizing humidity removal and filtration capabilities.
- Multi-poised: Can be used in horizontal, upflow, downflow and vertical applications.
- Built in Filter Rack: Makes the air handler easy to service.
- Plug-in Heater Kit: Available in 5 kW through 30 kW (Not for use in 115 Volt units)
- Circuit Board: Incorporating blower time delay relay, low voltage terminal strip, and heat-strip sequencing.
- Breaker Accessibility: Breaker accessible from the front of the unit when heater is applied.
- Plastic Drain Pan: Provides corrosion resistance.
- Durable Cabinet: Galvanized steel with a polyurethane finish. The finish will endure 950 hours of salt spray and resist corrosion 50% better than comparable units.
- Designed to meet the requirements 610.2.A.2: Meets Florida building code requirements for air leakage.
- Thermal Expansion Valve: Factory installed externally equalized thermal expansion valve provides precise refrigerant control under varying load conditions.
- Cabinet Insulation: 1" insulation with an R-value of 4.2 contributes to quiet operation and prevents cabinet sweating in difficult applications.
- Anteater™ Coil Technology: Copper alloy with zinc additives to stop formicary corrosion.